Register
4. Which 2D shape on the left would be used to make the 3D shape on the right? (1 pt.) a. . b.
207k views
16 votes
4. Which 2D shape on the left would be used to make the 3D shape on the right? (1 pt.)

a.
.
b.

4. Which 2D shape on the left would be used to make the 3D shape on the right? (1 pt-example-1
User IT Hit WebDAV
by
7.2k points

1 Answer

5 votes

it would be a bc its a sqare?well 3d is like you can say a cube 2d is like flat

Step-by-step explanation:

User Valverij
by
8.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.3m questions

10.9m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!