Register
Show how to connect the two circuit building blocks from the previous problem to create a circuit that transforms a priority-encoded input into a one-hot encoded output, where the highest-priority hot
41.5k views
3 votes
Show how to connect the two circuit building blocks from the previous problem to create a circuit that transforms a priority-encoded input into a one-hot encoded output, where the highest-priority hot signal from the input is the hot signal in the output.

User Ameeta
by
8.4k points

1 Answer

2 votes

Answer:

When xo =0, Do= 0, not 1

Step-by-step explanation:

Use 8×3 priority encoder and 3×8 decoder

Show how to connect the two circuit building blocks from the previous problem to create-example-1
User Blancos
by
7.4k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.7m questions

11.4m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Where are all the controls on most circuits?
Adding moisture is the ONLY way to obtain saturated air from unsaturated air. a)-True b) False
Link Copied!