Register
A 15 cm × 15 cm circuit board dissipating 20 W of power uniformly is cooled by air, which approached the circuit board at 20C with a velocity of 6 m/s. Assume the flow to be turbulent, since the electronic
196k views
0 votes
A 15 cm × 15 cm circuit board dissipating 20 W of power uniformly is cooled by air, which approached the circuit board at 20C with a velocity of 6 m/s. Assume the flow to be turbulent, since the electronic components are expected to act as turbulators. Disregard any heat transfer from the back surface of the board, and suppose that radiation heat transfer is negligible. Evaluate thermal properties of the air at a film temperature of 27C. Determine the surface temperature (C) of the electronic components at the following locations i) the leading edge of the board ii) the trailing edge of the board

User Paul Michaels
by
3.1k points

1 Answer

6 votes

Answer:

Step-by-step explanation:

Find attached the solution

A 15 cm × 15 cm circuit board dissipating 20 W of power uniformly is cooled by air-example-1
A 15 cm × 15 cm circuit board dissipating 20 W of power uniformly is cooled by air-example-2
A 15 cm × 15 cm circuit board dissipating 20 W of power uniformly is cooled by air-example-3
User Pupsik
by
3.6k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.3m questions

4.2m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
Regulation 433.3.3 gives six examples where th are permitted for safety reasons. Can you fill in the missing words? Exciter Drop zone for rotating machines. Supply circuits of lifting Dron zone
A machine component is subjected to an axial load that varies from 3000 lb compression to 5000 lb tension. Determine the combination of maximum and minimum stresses to which the member could probably be
Link Copied!