Register
A force that attempts to decrease the length of a structural member is____ a) axial b) tension c) compression d) vector
105k views
1 vote
A force that attempts to decrease the length of a structural member is____

a) axial
b) tension
c) compression
d) vector

A force that attempts to decrease the length of a structural member is____ a) axial-example-1
User Jackbot
by
8.1k points

2 Answers

3 votes
the answer is c because compression is he act of forcing an object into another
User Jdeanwallace
by
8.3k points
2 votes
I think its C) compression
User JBone
by
8.5k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A 200 g projectile is fired with a velocity of 900 m/s toward the center of a 15 kg wooden block which rests on a rough surface. If the projectile penetrates and emerges from the back at a velocity of
The pressure at any point in a static fluid depends only on the Select one a)- depth, surface pressure, and specific weight. b)- specific weight. c)- surface pressure and depth. d)- depth and container
If a host system is 80% efficient, the minimum horsepower rating of the motor should be ? if the hoist is to provide 20,000 ft-lb/s. a) 45.45hp b) 23,530hp c) 36.36hp d) 42.78hp
Link Copied!