Register
How are the accelerator and brake pedal positioned in relation to each other? A. The brake pedal is to the right of the accelerator pedal. B. The brake pedal is to the left of the accelerator pedal. C.
201k views
2 votes
How are the accelerator and brake pedal positioned in relation to each other? A. The brake pedal is to the right of the accelerator pedal. B. The brake pedal is to the left of the accelerator pedal. C. The brake pedal is above the accelerator pedal. D. The brake pedal is below the accelerator pedal.

User HariK
by
7.9k points

2 Answers

3 votes

Answer: B. The brake pedal is to the left of the accelerator pedal.

Step-by-step explanation:

User Jackdbernier
by
8.3k points
4 votes

Answer:B

Step-by-step explanation:

User Xonshiz
by
8.4k points
← Prev Question Next Question →

Related questions

User Cgee
asked Jul 18, 2024 9.4k views
Which of the following controls increases speed when pressed? 1) clutch pedal 2) brake 3) cruise 4) accelerator
Cgee asked Jul 18, 2024
by Cgee
8.6k points
1 answer
4 votes
9.4k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
Vitrification is a process of: a. Chemical reaction bonding of aggregate ceramic powder b. Cementing aggregate ceramic powder with a liquefied material c. Solid-state diffusion of aggregate ceramic powder
What claim do ghost hunters make about energy-detecting devices? They can determine how many spirits are in one location. They can produce sounds that may be confused with ghosts. They can sense the presence
A 200 g projectile is fired with a velocity of 900 m/s toward the center of a 15 kg wooden block which rests on a rough surface. If the projectile penetrates and emerges from the back at a velocity of
A face milling operation is to be performed on cast iron. Tool diameter is 5 inches, w = 2 inches, part length = 8 inches, depth of cut = 0.012 inches, f = 0.001 inch/tooth, and N = 250 RPM. Find: MRR,
Link Copied!