Register
During experiments on laser etching of microchips for IBM, a nuclear engineer places a discshaped sample 5 mm in diameter in a vacuum chamber with surface temperature of 300 K. A 500 mW laser is then used
75.6k views
5 votes
During experiments on laser etching of microchips for IBM, a nuclear engineer places a discshaped sample 5 mm in diameter in a vacuum chamber with surface temperature of 300 K. A 500 mW laser is then used to irradiate the sample uniformly. The sample surface can be considered ‘gray’ with an emissivity of 0.9 and can be considered ‘thin’ so that the disk temperature is uniform. In addition, a non-participating gas at a temperature of 27⁰C is used to cool the sample with a convection coefficient of 50 W/(m2K). Find the steady-state temperature of the disk

User Sorax
by
5.8k points

1 Answer

6 votes

Answer:

Steady state temperature is approximately 801K

Step-by-step explanation:

Detailed explanation and calculation is shown in the images below.

During experiments on laser etching of microchips for IBM, a nuclear engineer places-example-1
During experiments on laser etching of microchips for IBM, a nuclear engineer places-example-2
User JosephStevens
by
6.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

6.3m questions

8.3m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!