Register
A machine component is subjected to an axial load that varies from 3000 lb compression to 5000 lb tension. Determine the combination of maximum and minimum stresses to which the member could probably be
88,800 views
4 votes
4 votes
A machine component is subjected to an axial load that varies from 3000 lb compression to 5000 lb tension. Determine the combination of maximum and minimum stresses to which the member could probably be subjected millions of times without failure by slip or fracture if the proposed material is hardened and tempered 0.93 percent carbon spring-steel with an endurance limit of 56 ksi, a proportional limit of 85 ksi, and an ultimate strength of 97 ksi.

User Egil Hansen
by
2.9k points

2 Answers

5 votes
5 votes

Answer:

The maximum tensile stress is 60.10 Ksi

Step-by-step explanation:

A machine component is subjected to an axial load that varies from 3000 lb compression-example-1
User Xbrady
by
3.3k points
3 votes
3 votes

The answer and explanation is attached

A machine component is subjected to an axial load that varies from 3000 lb compression-example-1
User Spmason
by
3.0k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.1m questions

4.0m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
Regulation 433.3.3 gives six examples where th are permitted for safety reasons. Can you fill in the missing words? Exciter Drop zone for rotating machines. Supply circuits of lifting Dron zone
A machine component is subjected to an axial load that varies from 3000 lb compression to 5000 lb tension. Determine the combination of maximum and minimum stresses to which the member could probably be
Engine oil flows through a 25‐mm‐diameter tube at a rate of 0.5 kg/s. The oil enters the tube at a temperature of 25°C, while the tube surface temperature is maintained at 100°C. For a 100‐m long tube,
Link Copied!