Register
Design roller chain drive. Specify the chain size, the sizes and number of teeth in the sprockets, the number of chain pitches, and the center distance. Please, show step-by-step process using tables/charts/figures
52.9k views
5 votes
Design roller chain drive. Specify the chain size, the sizes and number of teeth in the sprockets, the number of chain pitches, and the center distance. Please, show step-by-step process using tables/charts/figures from textbook. a.Driver type: AC Motor b.Driven machine: Agitator c.Input speed: 750 rpm d.Input power: 5 hp e.Nominal output speed: 325 rpm

User Bagerard
by
3.7k points

1 Answer

5 votes

Answer:

The total design can be summarized as follows:

AC motor 55 hp, 750 rpm as a driver

Service factor 1.0

Design power 5 hp

No. 40 chain, 0.50 in pitch, 1 strands

17 teeth, 2.72 in pitch dia, 1 strand small sprocket

39 teeth, 7.46 in pitch dia, 1 strand large sprocket

1 strand of length 54 in

Center distance of 19.9 in

Actual Output speed of 326.9 rpm

Type B lubrication

Step-by-step explanation:

Design roller chain drive. Specify the chain size, the sizes and number of teeth in-example-1
Design roller chain drive. Specify the chain size, the sizes and number of teeth in-example-2
Design roller chain drive. Specify the chain size, the sizes and number of teeth in-example-3
Design roller chain drive. Specify the chain size, the sizes and number of teeth in-example-4
Design roller chain drive. Specify the chain size, the sizes and number of teeth in-example-5
User Aleksandr Petrovskij
by
3.2k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.3m questions

4.2m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
Regulation 433.3.3 gives six examples where th are permitted for safety reasons. Can you fill in the missing words? Exciter Drop zone for rotating machines. Supply circuits of lifting Dron zone
A machine component is subjected to an axial load that varies from 3000 lb compression to 5000 lb tension. Determine the combination of maximum and minimum stresses to which the member could probably be
Link Copied!