Register
the upper surface of a 1x1 ASTM B152 copper plate is being cooled by air at 20 c. if the rate of convection heat transfer from the plate surface is 700 W, would the use of ASTM B152 plate be in compliance
21.4k views
2 votes
the upper surface of a 1x1 ASTM B152 copper plate is being cooled by air at 20 c. if the rate of convection heat transfer from the plate surface is 700 W, would the use of ASTM B152 plate be in compliance with tht ASME Code for process piping?

User Leo The Lion
by
4.8k points

2 Answers

7 votes

Answer:

Since the Reynolds number is below 3 x 10⁵ the use of ASTM B152 plate WILL NOT be in complaince with ASME Code for process piping.

Step-by-step explanation:

Detailed Explanation is given in the attached document.

the upper surface of a 1x1 ASTM B152 copper plate is being cooled by air at 20 c. if-example-1
the upper surface of a 1x1 ASTM B152 copper plate is being cooled by air at 20 c. if-example-2
User JSS
by
5.6k points
5 votes

Answer:

No,the use of ASTM B152 plate be in compliance with that ASME Code for process piping since it wouldn't bear the required heat transfer rate.

User Khalil Meg
by
6.0k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.9m questions

7.6m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!