Register
Plot the absorbance, A, versus the FeSCN2 concentration of the standard solutions (the values from your Pre-lab assignment). From this calibration curve, determine the concentration of FeSCN2 in each of
41.9k views
3 votes
Plot the absorbance, A, versus the FeSCN2 concentration of the standard solutions (the values from your Pre-lab assignment). From this calibration curve, determine the concentration of FeSCN2 in each of the equilibrium solutions you prepared using their absorbance values. You should use the program Excel and the LINEST function to plot and analyze this data. You should report 6 values for [FeSCN2 ]eq.

User Gdm
by
7.3k points

1 Answer

6 votes

Answer:

Step-by-step explanation:

Detailed explanation is done in the attach document.

Plot the absorbance, A, versus the FeSCN2 concentration of the standard solutions-example-1
Plot the absorbance, A, versus the FeSCN2 concentration of the standard solutions-example-2
Plot the absorbance, A, versus the FeSCN2 concentration of the standard solutions-example-3
Plot the absorbance, A, versus the FeSCN2 concentration of the standard solutions-example-4
Plot the absorbance, A, versus the FeSCN2 concentration of the standard solutions-example-5
User Sketchthat
by
7.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.4m questions

11.1m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!