Register
enters a nozzle steadily at 50 psia, 1408F, and 150 ft/s and leaves at 14.7 psia and 900 ft/s. The heat loss from the nozzle is estimated to be 6.5 Btu/lbm of air flowing. The inlet area of the nozzle
179k views
1 vote
enters a nozzle steadily at 50 psia, 1408F, and 150 ft/s and leaves at 14.7 psia and 900 ft/s. The heat loss from the nozzle is estimated to be 6.5 Btu/lbm of air flowing. The inlet area of the nozzle is 0.1 ft2 . Determine (a) the exit temperature of air and (b) the exit area of the nozzle.

User Brandon Brown
by
7.4k points

1 Answer

1 vote

Answer:

Answer of the Both parts with explanation are in the following attachments

Step-by-step explanation:

enters a nozzle steadily at 50 psia, 1408F, and 150 ft/s and leaves at 14.7 psia and-example-1
enters a nozzle steadily at 50 psia, 1408F, and 150 ft/s and leaves at 14.7 psia and-example-2
User Kshitij Agarwal
by
8.0k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Where are all the controls on most circuits?
Link Copied!