Register
The following creep data were obtained for a titanium alloy at 50 ksi and 400 degrees C. (a) Plot the creep strain vs time (hours) and (b) determine the steady-state creep rate for the test conditionscol1
106k views
2 votes
The following creep data were obtained for a titanium alloy at 50 ksi and 400 degrees C. (a) Plot the creep strain vs time (hours) and (b) determine the steady-state creep rate for the test conditionscol1 Strain (in/in) 0.010x10-2 0.030x10-2 0.050x10-2 0.075x10-2 0.090x10-2 0.11x10-2

col2 Time (hr) 2 18 40 80 120 160

User Matt Klooster
by
7.4k points

1 Answer

3 votes

Answer:

a) See attached picture.

b) 6.25*10⁻⁶ hr⁻¹

Step-by-step explanation:

See attached picture for explanation.

The following creep data were obtained for a titanium alloy at 50 ksi and 400 degrees-example-1
User Danillouz
by
8.6k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.3m questions

12.0m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Where are all the controls on most circuits?
Adding moisture is the ONLY way to obtain saturated air from unsaturated air. a)-True b) False
Link Copied!