Register
Two technicians are discussing hand tool use. Technician A says that a 6-point wrench is easier to use in tight places than a 12-point. Technician B says that a ratchet is used to loosen fasteners that
206k views
2 votes
Two technicians are discussing hand tool use. Technician A says that a 6-point wrench is easier to use in tight places than a 12-point. Technician B says that a ratchet is used to loosen fasteners that are very tight. Who is correct?

User Ajaristi
by
3.3k points

2 Answers

2 votes

Answer:

A ratchet wrench is usually used to loosen and tighten parts like steering linkages, tie rod end clamps and muffler clamps. Basically when nut is used on long thread a ratchet wrench is being used.

hence the technician B (option b) is correct.

Step-by-step explanation:

User RoflcoptrException
by
3.3k points
3 votes

Answer:

Technician B says that a ratchet is used to loosen fasteners that are very tight.

Step-by-step explanation:

A ratchet is a common wrench device with a fastener component. A ratchet wrench is an essential tool that is used to fasten or loosen nuts and bolts.

User Igor Gilyazov
by
3.1k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.6m questions

4.6m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
Only an outer panel is being replaced. Technician A says that removing the spot welds by drilling through both panels allows the plug welds to be made through the replacement outer panel. Technician B
Solving for dominant strategies and the Nash equilibrium Suppose Andrew and Beth are playing a game in which both must simultaneously choose the action Left or Right. The payoff matrix that follows shows
Name the author the "the journey to the centre of the earth"​
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
Link Copied!