Register
A 13-tooth spur pinion has a module of 5 mm and runs at a speed of 1250 rev/min. The driven gear has 25 teeth. Find the speed of the driven gear, the circular pitch, and the theoretical center-to-center
235k views
3 votes
A 13-tooth spur pinion has a module of 5 mm and runs at a speed of 1250 rev/min. The driven gear has 25 teeth. Find the speed of the driven gear, the circular pitch, and the theoretical center-to-center distance.

User Neerajlal K
by
8.0k points

1 Answer

1 vote

The solution is in the attachment

A 13-tooth spur pinion has a module of 5 mm and runs at a speed of 1250 rev/min. The-example-1
User Initramfs
by
8.5k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!