Register
It is desired to increase the output of a spark-ignition engine (with a compression ratio of 8:1 and an inlet pressure 1.0 atm) by either: (1) raising the compression ratio from 8 to 11, or (2) increasing
156k views
5 votes
It is desired to increase the output of a spark-ignition engine (with a compression ratio of 8:1 and an inlet pressure 1.0 atm) by either: (1) raising the compression ratio from 8 to 11, or (2) increasing the inlet pressure from 1.0 atm to 1.8 atm Assume g = 1.3 and . Using the constant volume cycle as a model for engine operation, which procedure will give: a) The highest pressure in the cycle? b) The highest efficiency? c) The highest i.m.e.p.?

User LuLuGaGa
by
7.1k points

1 Answer

4 votes

Answer:

our answer is attached below

Step-by-step explanation:

It is desired to increase the output of a spark-ignition engine (with a compression-example-1
User Short
by
6.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.0m questions

10.6m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Adding moisture is the ONLY way to obtain saturated air from unsaturated air. a)-True b) False
Link Copied!