Register
6.27 The surface of a steel machine member is subjected to principal stresses of 200 MPa and 100 MPa. What tensile yield strength is required to provide a safety factor of 2 with respect to initial yielding:
218k views
4 votes
6.27 The surface of a steel machine member is subjected to principal stresses of 200 MPa and 100 MPa. What tensile yield strength is required to provide a safety factor of 2 with respect to initial yielding: According to the maximum‐shear‐stress theory? According to the maximum‐distortion‐energy theory? [Ans.: (a) 400 MPa, (b) 346 MPa]

User Marwin
by
6.9k points

1 Answer

1 vote

Answer:

(a) 400 MPa

(b) 346 MPa

Step-by-step explanation:

See the attached pictures for explanation.

6.27 The surface of a steel machine member is subjected to principal stresses of 200 MPa-example-1
6.27 The surface of a steel machine member is subjected to principal stresses of 200 MPa-example-2
User Kghbln
by
6.4k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

7.4m questions

10.0m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!