Register
A signal expected to be of the form F(t)=10sin15.7t is to be measured with a first-order instrument having a time constant of 50 ms. Find: Write the expected indicated steady response output signal. Is
185k views
0 votes
A signal expected to be of the form F(t)=10sin15.7t is to be measured with a first-order instrument having a time constant of 50 ms. Find: Write the expected indicated steady response output signal. Is this instrument a good choice for this measurement? What is the expected time lag between input and output signal? Plot the output amplitude spectrum. Use y(0)=0 and K =1V/V.

User Christian Maslen
by
6.8k points

1 Answer

0 votes

Answer:

The answer is attached below

Step-by-step explanation:

A signal expected to be of the form F(t)=10sin15.7t is to be measured with a first-example-1
A signal expected to be of the form F(t)=10sin15.7t is to be measured with a first-example-2
A signal expected to be of the form F(t)=10sin15.7t is to be measured with a first-example-3
User David Sauter
by
7.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

7.8m questions

10.5m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!