Register
Cleaning the shop's floor is being discussed. Technician A says to flush the waste and dust into a floor drain. Technician B says a wet/dry vacuum cleaner with a HEPA filter is the preferred method. Who
182k views
1 vote
Cleaning the shop's floor is being discussed. Technician A says to flush the waste and dust into a floor drain. Technician B says a wet/dry vacuum cleaner with a HEPA filter is the preferred method. Who is correct?

User Umutyerebakmaz
by
6.0k points

1 Answer

2 votes

Answer:

Technician B

Step-by-step explanation:

A HEPA or high-efficiency particulate Type filter is capable of capturing 99 percent of particles that are 2 microns or larger, high-efficiency particulate airsuch as pet dander and DUST. So this is the best answer. I hope you find this helpful!

User Daveswen
by
6.2k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

6.5m questions

8.6m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Link Copied!