Register
The passageway between the riser and the main cavity must have a small cross-sectional area to minimize waste of casting metal: True or False
211k views
3 votes
The passageway between the riser and the main cavity must have a small cross-sectional area to minimize waste of casting metal: True or False

User Bjan
by
7.9k points

1 Answer

4 votes

Answer:

True

Step-by-step explanation:

The passageway between the riser and the main cavity must have a small cross-sectional area to reduce waste of material in metal casting.

User Jpsstack
by
8.8k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Where are all the controls on most circuits?
Link Copied!