Register
A(n) _____________ is used commonly in open split-phase motors to disconnect the start winding from the electrical circuit when the motor reaches approximately 75% of its rated speed.
27.2k views
6 votes
A(n) _____________ is used commonly in open split-phase motors to disconnect the start winding from the electrical circuit when the motor reaches approximately 75% of its rated speed.

User Monti
by
7.8k points

1 Answer

6 votes

A centrifugal switch is used commonly in open split-phase motors to disconnect the start winding from the electrical circuit when the motor reaches approximately 75% of its rated speed.

Hope that helps!

User Jesper Mygind
by
7.4k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.4m questions

11.1m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Vitrification is a process of: a. Chemical reaction bonding of aggregate ceramic powder b. Cementing aggregate ceramic powder with a liquefied material c. Solid-state diffusion of aggregate ceramic powder
A 200 g projectile is fired with a velocity of 900 m/s toward the center of a 15 kg wooden block which rests on a rough surface. If the projectile penetrates and emerges from the back at a velocity of
A face milling operation is to be performed on cast iron. Tool diameter is 5 inches, w = 2 inches, part length = 8 inches, depth of cut = 0.012 inches, f = 0.001 inch/tooth, and N = 250 RPM. Find: MRR,
Link Copied!