Register
If outside of the flask is not dry when first determination is made and it is dried for second determination, what effect will that have on your result?
230k views
4 votes
If outside of the flask is not dry when first determination is made and it is dried for second determination, what effect will that have on your result?

User Victor Wang
by
3.4k points

1 Answer

4 votes

Answer:

The total mass determined in the second experiment will be lower than the total mass determined in the first experiment.

Step-by-step explanation:

If outside of the flask is not dry, the total mass = mass of flask + mass of water.

When outside of the flask is dried, the total mass = mass of flask only.

Thus, the total mass determined in the second experiment will be lower than the total mass determined in the first experiment.

Therefore, if outside of the flask is not dry when first determination is made and it is dried for second determination, the effect it will have on my result is, the total mass determined in the second experiment will be lower than the total mass determined in the first experiment.

User Clfaster
by
2.8k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.4m questions

4.3m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
A machine component is subjected to an axial load that varies from 3000 lb compression to 5000 lb tension. Determine the combination of maximum and minimum stresses to which the member could probably be
Engine oil flows through a 25‐mm‐diameter tube at a rate of 0.5 kg/s. The oil enters the tube at a temperature of 25°C, while the tube surface temperature is maintained at 100°C. For a 100‐m long tube,
Link Copied!