Register
Under EPA's regulations, which of the following methods can be used to pressurize an R11 or R123 system for the purpose of opening the system for a non-major repair? A. Adding nitrogen B. Warming the refrigerant
45.9k views
2 votes
Under EPA's regulations, which of the following methods can be used to pressurize an R11 or R123 system for the purpose of opening the system for a non-major repair?

A. Adding nitrogen
B. Warming the refrigerant
C. Adding compressed air
D. Adding carbon dioxide

User Parvesh Kumar
by
8.2k points

1 Answer

7 votes

Answer:

(A) Adding Nitrogen

Step-by-step explanation:

R11 or R123 are flammable substance under certain conditions when mixed with Oxygen, adding Nitrogen is a safety procedure used in displacing any R11 or R123 which are considered as hazardous when mixed with Oxygen.

User Lmagyar
by
8.7k points
← Prev Question Next Question →

Related questions

User Dan Noble
asked Mar 18, 2024 168k views
Refrigerant recovery from an R-11 or R123 system? 1) Yes 2) No
Dan Noble asked Mar 18, 2024
by Dan Noble
8.0k points
1 answer
4 votes
168k views
User Pearapon Joe
asked Jan 26, 2024 149k views
Which refrigerant can be mixed? A) R11 and R12 B) R12 and R134a C) R12 and R22 D) none of the above
Pearapon Joe asked Jan 26, 2024
by Pearapon Joe
7.9k points
1 answer
4 votes
149k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Where are all the controls on most circuits?
Link Copied!