Register
8. What side length would you specify if you were required to create a regular hexagonal plate that was comprised of 33 cm- of sheet metal? Bonus: Sketch the hexagon, dimension the side length on the sketch
24.3k views
5 votes
8. What side length would you specify if you were required to create a regular

hexagonal plate that was comprised of 33 cm- of sheet metal?
Bonus: Sketch the hexagon, dimension the side length on the sketch to 0.1 cm,
and indicate your grid spacing. Justify your dimension.

User Eni
by
3.1k points

2 Answers

5 votes

Answer:

im sorry idk

Step-by-step explanation:

User Randyjp
by
3.7k points
4 votes

Answer:hey

Step-by-step explanation:

User Dvhh
by
3.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.3m questions

4.3m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
Regulation 433.3.3 gives six examples where th are permitted for safety reasons. Can you fill in the missing words? Exciter Drop zone for rotating machines. Supply circuits of lifting Dron zone
Engine oil flows through a 25‐mm‐diameter tube at a rate of 0.5 kg/s. The oil enters the tube at a temperature of 25°C, while the tube surface temperature is maintained at 100°C. For a 100‐m long tube,
Link Copied!