Register
1. Select the punch that is used to make a mark in metal before drilling A Taper punch B. Pin punch OC. Diamond point punch D. Center punch
202k views
2 votes
1. Select the punch that is used to make a mark in metal

before drilling
A Taper punch
B. Pin punch
OC. Diamond point punch
D. Center punch

User Matt Pavelle
by
8.4k points

1 Answer

5 votes

Answer:

D center punch

Step-by-step explanation:

it has a fine point so it is good with accuracy

User C R Johnson
by
7.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.1m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Adding moisture is the ONLY way to obtain saturated air from unsaturated air. a)-True b) False
Link Copied!