Register
The threaded movable part that rotates on a micrometer is called the _______ a. Sleeve b. Thimble c. Spindle d. Anvil
119k views
8 votes
The threaded movable part that rotates on a micrometer is called the _______

a. Sleeve
b. Thimble
c. Spindle
d. Anvil

User Bergi
by
9.5k points

1 Answer

13 votes

Answer:

C

Step-by-step explanation:

The Anvil is the stationary part of the tool, the spindle is the threaded moveable part

User Stianlagstad
by
9.1k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Where are all the controls on most circuits?
A three-point bending test was performed on an aluminum oxide specimen having a circular cross section of radius 3.5 mm (0.14 in.); the specimen fractured at a load of 950 N (215 lbf) when the distance
Link Copied!