Question

How to experiment titration ​

Answer 1

To conduct a titration experiment, first fill the burette with an acid or base solution of known concentration. After that, take a burette reading from the top of the miniscus down to the bottom. Then, underneath the burette, place a flask containing an unknown concentration of acid or base. After that, fill the flask halfway with the appropriate indicator and shake it up. Add your titrate to the flask one drop at a time while stirring constantly. Continue to add the titrate until the color change is noticeable. Finally, take one more look at the burette to make sure everything is correct.

Step-by-step explanation:

Hope it helps:)

Answer 2

Add a volume of a solution of known concentration is added to a volume of another solution in order to determine its concentration. Solutions in which a few drops of phenolphthalein have been added turn from colorless to brilliant pink as the solution turns from acidic to basic.

If you want the method:

Method

1) Use a pipette and pipette filler to add 25 cm3 of alkali solution to a clean conical flask.

2) Add a few drops of a suitable indicator and put the conical flask on a white tile.

3) Fill the burette with dilute acid. Flush the tap through to remove any air bubbles. Ensure the burette is vertical.

4) Slowly add the acid from the burette to the conical flask, swirling to mix. (The mixture may at first change colour, and then back again when swirled.)

5) Stop adding the acid when the end-point is reached (when the colour first permanently changes). Note the final volume reading.

6) Repeat steps 1 to 5 until three results are repeatable (in close agreement). Ideally these should lie within 0.10 cm3 of each other.

I hope it helps.