Register
Technician A says that when removing a hubless-style drum, you should first make matching marks on the drum and hub for reinstallation in the correct position.
198k views
1 vote
Technician A says that when removing a hubless-style drum, you should first make matching marks on the drum and hub for reinstallation in the correct position.

User Konstantin Labun
by
3.2k points

1 Answer

4 votes

Answer:

gawain sa pagkatuto bilang 2 balikan ang awiting bayan ko sa pahina 15 hanapin ang mga simbolong pangmusika sa awiting guhit ang mga nakita mong simbolong pangmusika sa iyong kwaderno

User Shawn Erquhart
by
4.0k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.3m questions

4.2m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
Regulation 433.3.3 gives six examples where th are permitted for safety reasons. Can you fill in the missing words? Exciter Drop zone for rotating machines. Supply circuits of lifting Dron zone
A machine component is subjected to an axial load that varies from 3000 lb compression to 5000 lb tension. Determine the combination of maximum and minimum stresses to which the member could probably be
Link Copied!