Register
The low-pressure side of the system must not be pressurized to more than:
154k views
0 votes
The low-pressure side of the system must not be pressurized to more than:

User SpongeBobFan
by
8.2k points

1 Answer

0 votes

Answer:

The low side must not be pressurize past the low side design pressure.

Step-by-step explanation:

User Zeigeist
by
7.7k points
← Prev Question Next Question →

No related questions found

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Where are all the controls on most circuits?
Adding moisture is the ONLY way to obtain saturated air from unsaturated air. a)-True b) False
Link Copied!