Register
What make metal ductwork more desirable than flex duct? Less friction loss Less chance of restriction More direct routes to boots All of the above
141k views
21 votes
What make metal ductwork more desirable than flex duct?

Less friction loss

Less chance of restriction

More direct routes to boots

All of the above

User Newlogic
by
7.2k points

1 Answer

7 votes
I think all of the above
Hope this helps
User Ekerner
by
7.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

7.9m questions

10.6m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Adding moisture is the ONLY way to obtain saturated air from unsaturated air. a)-True b) False
Link Copied!