Register
When you select multiple edges to Chamfer, a flag is displayed on each edge and each one can be given individual Chamfer dimensions. Select Answer FALSE TRUE
112k views
1 vote
When you select multiple edges to Chamfer, a flag is

displayed on each edge and each one can be given individual
Chamfer dimensions.
Select Answer
FALSE
TRUE

User Dewayne
by
8.2k points

2 Answers

1 vote
true. i think. hope you get it right
User Kikito
by
7.3k points
3 votes
I think the answer is true
User Scott Montgomerie
by
7.4k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.3m questions

12.0m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Where are all the controls on most circuits?
Link Copied!