Register
The voltage drop across an LED is 2 Volts. It is connected to a 5 volt power supply with a resistor, as shown. What resistor value should be used to set the LED current to 4 mA?
159k views
0 votes
The voltage drop across an LED is 2 Volts. It is connected to a 5 volt power supply with a resistor, as shown. What resistor value should be used to set the LED current to 4 mA?

The voltage drop across an LED is 2 Volts. It is connected to a 5 volt power supply-example-1
User Eldar Markov
by
7.4k points

1 Answer

3 votes

Answer:

Step-by-step explanation:

The voltage drop across an LED is 2 Volts. It is connected to a 5 volt power supply

so voltage at resistor = 5-2 = 3V

by ohms' law, V=IR n current at 4mA or 0.004A

R = 3/0.004 = 750 ohms

User Primo
by
9.1k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!