Register
When trying to determine plumb or level, the contact the surface of the level should 1 face 2 edge 3 end 4 all the above
127k views
4 votes
When trying to determine plumb or level, the

contact the surface
of the level should
1 face
2 edge
3 end
4 all the above

User Brduca
by
3.2k points

2 Answers

2 votes
Add me please add please help please add add please please
User Moltarze
by
3.2k points
7 votes
4 is your answer so it is all above
User Xpuu
by
3.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.4m questions

4.3m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
Name the author the "the journey to the centre of the earth"​
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
A machine component is subjected to an axial load that varies from 3000 lb compression to 5000 lb tension. Determine the combination of maximum and minimum stresses to which the member could probably be
Link Copied!