Register
Which starting circuit uses fuses, switches, and smaller wires to energize a relay and solenoid? Starter Main Circuit Starter Control Circuit Starter Ground Path Battery Positive Cable
20.3k views
5 votes
Which starting circuit uses fuses, switches, and smaller wires to energize a relay and solenoid?

Starter Main Circuit
Starter Control Circuit
Starter Ground Path
Battery Positive Cable

User Vanangamudi
by
5.5k points

1 Answer

1 vote

Answer:

Option B (Starter Control Circuit) is the right option.

Step-by-step explanation:

  • This same switching is normally put upon this isolated side of something like the transmission Arduino microcontroller throughout the configuration that is using the ignition just to command the broadcast.
  • It uses a secondary relay isolated to regulate electrical current throughout the solenoid starting system.

All other given options are not related to the given instance. So the above option is correct.

User Luke Le
by
5.2k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

6.0m questions

7.8m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!