Register
Technician A says that when inflating tires, you should check the tire placard for the correct recommended pressure. Technician B says that you can tell when a tire is fully inflated by looking at it.
112k views
1 vote
Technician A says that when inflating tires, you should check the tire

placard for the correct recommended pressure. Technician B says that you
can tell when a tire is fully inflated by looking at it. Who is correct?
Technician A
Technician B
Both Technician A and Technician B
Neither Technician A nor Technician B

User Kidus
by
4.7k points

1 Answer

4 votes
Technician A when you inflate a tire it’s always best to look at the condition of tire to prevent blow outs and always use a pressure tool to make sure the tire is inflated to manufacture specifications
User Mortana
by
5.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.6m questions

7.3m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Link Copied!