Register
An axial flow pump is to discharge 5 cusecs at an operating speed of 1450 rev/min. The inner and outer diameters of the impeller are to be 5.5 in. and 11 in. respectively. If the head developed according
151k views
4 votes
An axial flow pump is to discharge 5 cusecs at an operating speed of 1450 rev/min. The inner and outer diameters of the impeller are to be 5.5 in. and 11 in. respectively. If the head developed according to the vector triangles is 20 ft, determine the angle of the vane tips at the inner and outer diameters and the corresponding diffuser blade angle (the diffuser blades are the stationary blades after the impeller).

User Josefina
by
3.1k points

1 Answer

4 votes

Answer:

if you want it to go faster add chain

Step-by-step explanation:

User Gena Kukartsev
by
3.6k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.3m questions

4.2m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
Regulation 433.3.3 gives six examples where th are permitted for safety reasons. Can you fill in the missing words? Exciter Drop zone for rotating machines. Supply circuits of lifting Dron zone
A machine component is subjected to an axial load that varies from 3000 lb compression to 5000 lb tension. Determine the combination of maximum and minimum stresses to which the member could probably be
Link Copied!