Register

1. The weld bead in SMAW is formed by the a. electrode wire core alone b. base metal mixing with the flux c. flux coating d. electrode wire core mixing with molten base metal

1. The weld bead in SMAW is formed by the a. electrode wire core alone b. base metal mixing with the flux c. flux coating d. electrode wire core mixing with molten base metal
130k views
4 votes
1. The weld bead in SMAW is formed by the

a. electrode wire core alone
b. base metal mixing with the flux
c. flux coating
d. electrode wire core mixing with molten base metal

User Yclian
by
8.1k points

1 Answer

12 votes

Answer:

a. electrode wire core alone

User Kfis
by
8.4k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Categories

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
Link Copied!