Register
why would it be inappropriate to dimension to a feature on a surface that is not perpendicular to the line of sight?
192k views
2 votes
why would it be inappropriate to dimension to a feature on a surface that is not perpendicular to the line of sight?

User Rherroral
by
3.5k points

1 Answer

5 votes
if you are drawing and dimensioning with a computer program the dimension will be inaccurate... If it is mechanical drawing then the fabricator would not have enough information to accurately measure the component. ie a circle turned a few degrees away from perp. would appear to be an ellipse. and may actually dimension that way
User Mandeep Yadav
by
3.8k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.7m questions

4.8m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
Only an outer panel is being replaced. Technician A says that removing the spot welds by drilling through both panels allows the plug welds to be made through the replacement outer panel. Technician B
What are the main causes of injuries when using forklifts?
Solving for dominant strategies and the Nash equilibrium Suppose Andrew and Beth are playing a game in which both must simultaneously choose the action Left or Right. The payoff matrix that follows shows
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
Link Copied!