Register
Yeah order for a firm voltage dividers to operate properly The load resistance value should be at least Times greater than resistance value of the voltage divider bleeder resistor
9.7k views
5 votes
Yeah order for a firm voltage dividers to operate properly The load resistance value should be at least Times greater than resistance value of the voltage divider bleeder resistor

User Lemon Kazi
by
6.8k points

1 Answer

4 votes

Answer:

A voltage divider is a simple series resistor circuit. It's output voltage is a fixed fraction of its input voltage. The divide-down ratio is determined by two resistors.

User Silentsudo
by
6.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

7.6m questions

10.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Where are all the controls on most circuits?
Link Copied!