Register

The tailstock a. is used to mount the lathe center b. cannot be used for taper turning C. is removed when long work must be turned D. holds the inner end of the work being turne…

The tailstock a. is used to mount the lathe center b. cannot be used for taper turning C. is removed when long work must be turned D. holds the inner end of the work being turne…
145k views
0 votes
The tailstock

a. is used to mount the lathe center
b. cannot be used for taper turning
C. is removed when long work must be turned
D. holds the inner end of the work being turned

User Weisj
by
8.2k points

1 Answer

5 votes
the anwser is c or d
User Pedrouan
by
7.9k points
← Prev Question Next Question →

Related questions

User Takeshin
asked Oct 8, 2021 145k views
The Tailstock setover for a 10 inch long peice needing a 0.18 inch taper per fot is _____ inches?
Takeshin asked Oct 8, 2021
by Takeshin
8.1k points
1 answer
3 votes
145k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Categories

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
Link Copied!