Register
How does an acety-lene hose connector differ from a connector used for an oxygen hose?
23.7k views
5 votes
How does an acety-lene hose connector differ from a connector used for an oxygen hose?

User Yoav Sternberg
by
7.3k points

2 Answers

0 votes

Answer:

The oxygen hose threads are usually right-handed, whereas acetylene and fuel gas hose threads are left-handed.

User Spudwaffle
by
8.0k points
3 votes
The oxygen hose threads are usually right-handed, whereas acetylene and fuel gas hose threads are left-handed
User Yale Newman
by
7.8k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.6m questions

11.3m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!