Register
For which of the following reasons may it be necessary to disassemble a master cylinder? a. Increase of brake fluid tevel b. Replacement of intemal parts c. Release of fluid pressure in the system d. Removal
200k views
10 votes
For which of the following reasons may it be necessary to disassemble a master cylinder?

a. Increase of brake fluid tevel
b. Replacement of intemal parts
c. Release of fluid pressure in the system
d. Removal of air in the system

User Eid
by
7.4k points

1 Answer

6 votes

Answer: One of the most common reasons why you may have a master cylinder-related spongy brake pedal is worn-out rubber seals. These are important parts of the brake master cylinder

Step-by-step explanation:

User Ngb
by
8.6k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Vitrification is a process of: a. Chemical reaction bonding of aggregate ceramic powder b. Cementing aggregate ceramic powder with a liquefied material c. Solid-state diffusion of aggregate ceramic powder
Link Copied!