Register
Which of the following describes seeing a three-dimensional object using only a single view? dimension projection third-angle projection orthographic projection isometric projection
8.8k views
6 votes
Which of the following describes seeing a three-dimensional object using only a single view?

dimension projection

third-angle projection

orthographic projection

isometric projection

User MoTSCHIGGE
by
7.9k points

2 Answers

10 votes

Answer:

isometric projection

Step-by-step explanation:

User Basem Sayej
by
8.0k points
6 votes

Answer:

answer is isometric projection edge 2022

Step-by-step explanation:

got it right

User Chetan J
by
8.1k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.2m questions

11.9m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!