Register
19. A hole is at LMC when the diameter is at the A. minimum allowable tolerance. B. maximum allowable tolerance. O C. feature size tolerance. O D. tolerance zone.
19.1k views
3 votes
19. A hole is at LMC when the diameter is at the

A. minimum allowable tolerance.
B. maximum allowable tolerance.
O C. feature size tolerance.
O D. tolerance zone.

User Stdclass
by
7.9k points

1 Answer

4 votes
The answer is
D. tolerance zone
User Jaspreet Jolly
by
7.4k points
← Prev Question Next Question →

Related questions

User Vitalygolub
asked Dec 2, 2024 219k views
Find m2CMN if m/LMC = 71x + 1, m/LMN = 118°, and m/CMN = 45x + 1. L M N
Vitalygolub asked Dec 2, 2024
by Vitalygolub
8.3k points
2 answers
0 votes
219k views
User Debu
asked Oct 28, 2024 195k views
The LMC of 12 and 7 is
Debu asked Oct 28, 2024
by Debu
8.0k points
1 answer
1 vote
195k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Adding moisture is the ONLY way to obtain saturated air from unsaturated air. a)-True b) False
Link Copied!