Register
1.3 A tensile load of 50,000 lb is applied to a metal bar with a 0.6 in. x 0.6 in. cross section and a gauge length of 2 in. Under this load, the bar elastically deforms so that the gauge length increases
20.8k views
0 votes
1.3

A tensile load of 50,000 lb is applied to a metal bar with a 0.6 in. x 0.6 in.
cross section and a gauge length of 2 in. Under this load, the bar elastically
deforms so that the gauge length increases to 2.007 in. and the cross section
decreases to 0.599 in. x 0.599 in. Determine the modulus of elasticity and
Poisson's ratio for this metal.

User Ferdinando
by
6.8k points

1 Answer

4 votes

Answer:

modulus =3.97X10^6 Ib/in^2, Poisson's ratio = 0.048

Step-by-step explanation:

User Stephen Gilboy
by
6.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

7.2m questions

9.5m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
A 200 g projectile is fired with a velocity of 900 m/s toward the center of a 15 kg wooden block which rests on a rough surface. If the projectile penetrates and emerges from the back at a velocity of
Link Copied!