Register
Which process can determine the difference between a part's actual, measured dimension and the expected dimension? POSSIBLE ANSWERS: O Calibration OGaging O Part tolerancing OVariable inspection
85.7k views
0 votes
Which process can determine the difference between a part's actual, measured dimension

and the expected dimension?
POSSIBLE ANSWERS:
O Calibration
OGaging
O Part tolerancing
OVariable inspection

User IStar
by
8.4k points

1 Answer

5 votes

Answer: Part tolerancing

User Keitaro Urashima
by
8.8k points
← Prev Question Next Question →

Related questions

User Edgar Navasardyan
asked Apr 21, 2024 17.9k views
Dimensioning and tolerancing shall be _____ so there is _____.
Edgar Navasardyan asked Apr 21, 2024
by Edgar Navasardyan
7.8k points
1 answer
0 votes
17.9k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Where are all the controls on most circuits?
Link Copied!