Register
A fastener that uses threads on both ends is called a
11.2k views
5 votes
A fastener that uses threads on both ends is called a

User Casper Wilkes
by
7.9k points

1 Answer

5 votes

Answer:

stud

Step-by-step explanation:

yes yes yes yes yes yes yes yes yes

User EverPresent
by
6.6k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.6m questions

11.3m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Adding moisture is the ONLY way to obtain saturated air from unsaturated air. a)-True b) False
Link Copied!