Answer: See below
Step-by-step explanation:
-Install two SATA hard drives in the computer.
-Initialize both disks using the MBR partition style.
-Create a volume on Disk 1 with the following properties:
-Volume size: 300000 MB
-Drive letter: E:File system: NTFS
-Volume label: Data
-Create a second volume using the remaining space on Disk 1 and all of the space on Disk 2 as follows:
-Drive letter: S:File system: NTFS
-Volume label: Art
Install two SATA hard drives as follows:
-Above the computer, select Motherboard to switch to the motherboard view.
-Click Yes to power off the system.
On the Shelf, expand Hard Drives.
-Drag a hard drive to a free 3.5" drive bay.
-Drag a second hard drive to a free 3.5" drive bay.
-On the Shelf, expand Cables.
-Select a SATA cable.
-Under Selected Component, drag a connector to the hard drive.
-Under Selected Component, drag the other connector to the motherboard SATA connector to connect the hard drive to the motherboard.
-Repeat step 1g-1i to connect the second hard drive to the motherboard.
-Under Partial Connections above the computer, select the power supply.
-Under Selected Component, drag a SATA power connector to a hard drive to provide power to the hard drive.
-Under Selected Component, drag a SATA power connector to the second hard drive.
-Initialize both disks using the MBR partition style as follows:
-Above the computer, select Front to switch to the front view of the computer.
-Click the power button on the computer to turn the computer on.
-After Windows loads, right-click Start and select Disk Management.
-Make sure MBR is selected as the partition style.
-Select OK to initialize all disks.
-Maximize the Disk Management window for easier viewing.
Create the Data volume as follows:
-Right-click the unallocated space on Disk 1 and select New Simple Volume.
-Click Next.
-In the Simple volume size in MB field, enter 300000 MB; then click Next.
-From the Assign the following drive letter drop-down list, select E.
-Click Next.
-Make sure NTFS is selected as the file system.
-In the Volume label, enter Data.
-Click Next.
-Click Finish.
Create the Art volume as follows:
-Rght-click unallocated space on one of the disks and select New Spanned Volume.
-Click Next.
-Under Available, select the disk.
-Select Add.
-Click Next.
-From the Assign the following drive letter drop-down list, select S.
-Click Next.
-Make sure NTFS is selected as the file system.
-In the Volume label, enter Art.
-Click Next.
-Click Finish.
-Click Yes to upgrade the disks to dynamic disks because spanned volumes can only be created on dynamic disks.