Register

The of a piston will generally be 0.030" to 0.040 (0.76 to 1.02 mm) smaller in diameter than the skirt. (A) pin boss (B) piston pin (C) head (D) connecting rod

The of a piston will generally be 0.030" to 0.040 (0.76 to 1.02 mm) smaller in diameter than the skirt. (A) pin boss (B) piston pin (C) head (D) connecting rod
22.0k views
1 vote
The

of a piston will generally be 0.030" to 0.040
(0.76 to 1.02 mm) smaller in diameter than the skirt.
(A) pin boss
(B) piston pin
(C) head
(D) connecting rod

User Darxtrix
by
7.5k points

1 Answer

0 votes
B I think hope you get it right
User Evil Spork
by
8.1k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Categories

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!