Register
Prefabricated lead flashings for vent pipe penetrations must have a sheet weight of not less than __________ pounds per square foot. a. 3.5 b. 2.5 c. 1.25 d. 0.75
26.9k views
1 vote
Prefabricated lead flashings for vent pipe penetrations must have a sheet weight of not less than __________ pounds per square foot. a. 3.5 b. 2.5 c. 1.25 d. 0.75

User Apan
by
8.4k points

1 Answer

2 votes
3.5 pounds per square foot.
User DanielBK
by
7.8k points
← Prev Question Next Question →

Related questions

User Bananach
asked May 16, 2024 28.4k views
Where is roof most likely to leak when re-roofing? a. Edge b. Penetrations c. Valleys d. Gable ends
Bananach asked May 16, 2024
by Bananach
7.9k points
1 answer
1 vote
28.4k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Teresa is emotionally volatile, particularly with friends and boyfriends. She is extremely dramatic about even the smallest disappointments and is sexually and behaviorally very impulsive. Teresa would
Link Copied!