Register
for flow of water at a reynolds number of 1.03 x 106 through a 5 cm diameter pipe of roughness height 0.5 mm, the approximate moody friction factor is
110k views
5 votes
for flow of water at a reynolds number of 1.03 x 106 through a 5 cm diameter pipe of roughness height 0.5 mm, the approximate moody friction factor is

User Tijko
by
7.7k points

1 Answer

3 votes

Answer:

I’m not sure bro

Step-by-step explanation:

I give up man

User Glenn Pierce
by
7.9k points
← Prev Question Next Question →

Related questions

User Tomfl
asked Mar 10, 2024 231k views
Explain in 5 lines why Reynolds number is used in the Moody Diagram instead of Froude number.
Tomfl asked Mar 10, 2024
by Tomfl
7.2k points
1 answer
1 vote
231k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Where are all the controls on most circuits?
Link Copied!